AudioRoundTable.com: Pi Speakers » Wayne, bracing restricting port flow?

Home » Sponsored » Pi Speakers » Wayne, bracing restricting port flow?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Yes, Adam [message #34846 is a reply to message #34844]

Tue, 22 January 2002 13:47

Wayne Parham
Messages: 18845
Registered: January 2001

Illuminati (33rd Degree)

Yes, absolutely. Preload can be applied by mechanical braces instead of filling the dead area with expansion foam. I like the expansion foam because it makes a solid damping mass, but you can also leave that area open as long as you use adequate bracing on the panels to keep them from vibrating.

Report message to a moderator

[Message index]

		Wayne, bracing restricting port flow? By: Adam on Tue, 22 January 2002 08:16
		oops... here's the picture... By: Adam on Tue, 22 January 2002 08:16
		Volume = capacitance; Restriction = resistance By: Wayne Parham on Tue, 22 January 2002 08:38
		Re: Volume = capacitance; Restriction = resistance By: Adam on Tue, 22 January 2002 10:26
		Re: Volume = capacitance; Restriction = resistance By: Wayne Parham on Tue, 22 January 2002 12:48
		Re: Volume = capacitance; Restriction = resistance By: Adam on Tue, 22 January 2002 13:08
		Hey Wayne? By: Adam on Tue, 22 January 2002 13:26
		Yes, Adam By: Wayne Parham on Tue, 22 January 2002 13:47
		Re: Yes, Adam By: Adam on Tue, 22 January 2002 15:11
		Re: Volume = capacitance; Restriction = resistance By: Wayne Parham on Tue, 22 January 2002 13:32

Previous Topic:	Four Pi Bass Reflex Driver mix of JBL HF motor & Delta 15 Pro
Next Topic:	has anyone else used "minimal expansion" foam,

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Mar 12 19:26:14 CDT 2025