Home » Sponsored » Pi Speakers » Any thoughts about the Peavey 22XT?
Any thoughts about the Peavey 22XT? [message #33372] Tue, 22 May 2001 21:49 Go to previous message
Bridgetown is currently offline  Bridgetown
Messages: 9
Registered: May 2009
Esquire
I am about to start building my Pi7 horns, recently received the plans recently from Wayne. I have a pair of Peavey 22XT compression drivers. I have not seen any discussion about Peavey 22XT in the forum and I am not sure if this driver would make a suitable as high frequency unit for the Pi7.

The specifications are as follows:
Throat parameter: 1"
Nonimal impedenance: 8 ohms
Sensitivity : 111dB SPL 1w/1m on a CH-2 horn
Frequency range: 500-20,000 Hz
Frequency range: +/- 2dB 500-3,200 Hz, -3dB@8,000 Hz
6dB roll off from 8,000-20,000 Hz
Diaphragm: titanium
Power capacity : 40 watts

I would appreciate any comments regarding its suitability and possible compensation network.
Regards

 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Theater Seven Pi--so far so good!
Next Topic: Where to buy JBL2426 diaphrams?
Goto Forum:
  


Current Time: Tue Nov 19 02:21:35 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest