Home » Audio » Group Build » Group Build Line Array Project
Power Requirements [message #32099 is a reply to message #32096] Tue, 31 October 2006 08:55 Go to previous messageGo to previous message
FredT is currently offline  FredT
Messages: 704
Registered: May 2009
Illuminati (1st Degree)
To answer your question more specifically, line arrays are capable of some very impressive dynamics. You can turn the volume up well beyond the point where a point source speaker would begin to sound congested, and a line array will still sound clear and relaxed. If you don't have the power to reach these levels you won't be able to realize one of the most important capabilities of your speakers.

The eight watts of my 300B SET amp will power them to levels that begin to realize this potential. I also tried them with the 3.5 watt 2A3 Paramours, and these are fine if you listen only to jazz, acoustic music, and early classical, but they begin to sound congested with highly dynamic music at room filling levels. I haven't tried any higher power tube amps yet, but I expect about 25 tube watts or 50 solid state watts is all the power you would want.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Smith horns
Next Topic: AudioRoundTable Group Build Room?
Goto Forum:
  


Current Time: Sun Nov 24 02:39:24 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest