AudioRoundTable.com: Group Build » If your thinking about an aluminum top plate and using a nibbler.....

Home » Audio » Group Build » If your thinking about an aluminum top plate and using a nibbler.....

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Yo, Shane [message #32079 is a reply to message #32076]

Sat, 21 October 2006 20:42

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

On Line Metals is where I got the amp plate. 1/8" 6065 aluminum. Prices are good but the shipping always seems kinda high. Also, don't expect shiny smooth. Both this aluminum and a brass plate I used for the Cornet had scratches, some deep.

I also found out that standard powder coating from my local source was very smooth and not that durable. Textured is better and that's what I'll get next time.

On Line Metals

Report message to a moderator

[Message index]

		If your thinking about an aluminum top plate and using a nibbler..... By: Bill Epstein on Mon, 02 October 2006 18:27
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: cfranz on Tue, 03 October 2006 08:20
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Wayne Parham on Tue, 03 October 2006 08:47
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: cfranz on Tue, 03 October 2006 09:01
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Wayne Parham on Tue, 03 October 2006 12:35
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Forty2wo on Tue, 03 October 2006 21:50
		Where'd ya get em' By: Shane on Tue, 03 October 2006 16:49
		Re: Where'd ya get em' By: Bill Epstein on Tue, 03 October 2006 20:00
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: SteveBrown on Thu, 05 October 2006 11:54
		Re: Hey Steve, By: Bill Epstein on Thu, 05 October 2006 15:49
		Re: Hey Steve, By: SteveBrown on Thu, 05 October 2006 18:40
		Sourcing for plate By: Shane on Tue, 17 October 2006 16:47
		Re: Sourcing for plate By: Wayne Parham on Sat, 21 October 2006 17:47
		Re: Yo, Shane By: Bill Epstein on Sat, 21 October 2006 20:42

Previous Topic:	The "Evil" Dr. Brown
Next Topic:	300B SE Project, Part 8 - Common cathode 6SN7 triode driver

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Feb 19 14:30:59 CST 2025