AudioRoundTable.com: Group Build

Home » Audio » Group Build » the Amp

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: the Amp [message #30850 is a reply to message #30848]

Sat, 05 March 2005 18:40

Manualblock
Messages: 4973
Registered: May 2009

Illuminati (13th Degree)

Sounds good to me.
Now I just need a little TLC.
On the filament trans I ran one wire from the secondary to each lug on a strip then connected a diode on each lug to the secondary wires. from there I tookthe opposite end of both diodesd and soldered them to one end of a two ohm resistor. I then took the other end of the resistor and soldered it to the pos. end of the first filter cap, with the other end of the filter cap to ground. I also grounded the CT of the RS trans.secondary.
Then I took one end of the second 2 ohm resistor and tied that to the pos end of the second filter cap and ran the neg end of the cap to ground. I then took the tab with the res/cap pos end and ran a wire to pin 4 of the 5687. I then ran a wire from pin 5 to ground. Is this correct?

Report message to a moderator

[Message index]

		the Amp By: PakProtector on Sat, 05 March 2005 17:54
		Re: the Amp By: Manualblock on Sat, 05 March 2005 18:40
		Re: the Amp By: PakProtector on Sat, 05 March 2005 18:54
		PCB for CCS By: colinhester on Sat, 05 March 2005 19:50
		Re: PCB for CCS By: PakProtector on Sat, 05 March 2005 20:37
		Re: PCB for CCS By: Manualblock on Sun, 06 March 2005 05:46
		T-220 mounting sockets By: colinhester on Sun, 06 March 2005 06:16
		Re: T-220 mounting sockets By: Manualblock on Sun, 06 March 2005 07:29
		No minimum but a service charge By: colinhester on Sun, 06 March 2005 08:55
		Re: No minimum but a service charge By: Manualblock on Sun, 06 March 2005 09:05
		Re: PCB for CCS By: Wayne Parham on Sat, 05 March 2005 23:15
		Re: the Amp By: Wayne Parham on Sat, 05 March 2005 23:13
		1619's By: cheetah on Mon, 07 March 2005 15:08

Previous Topic:	Building something new is not easy thing...
Next Topic:	Location of Selector Switch in Preamp

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Feb 25 08:26:19 CST 2025