AudioRoundTable.com: Group Build

Home » Audio » Group Build » Filament Caps

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Less ripple w/10k uF [message #30816 is a reply to message #30815]

Fri, 04 March 2005 08:47

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Ran a PSU simulation using 4.7k vs. 10k uF in the RCRC heater. 10k gives a lot less ripple if used in the first position (the one closest to the diodes) A change in ripple was not even noticed if the value was increased in the second position (cap closest to load) From this, you might want to hold off and use the 10k's. It sure looks like you'll be better off.....Colin

Report message to a moderator

[Message index]

		Filament Caps By: Manualblock on Fri, 04 March 2005 06:47
		That's what I used By: colinhester on Fri, 04 March 2005 08:03
		Re: That's what I used By: Manualblock on Fri, 04 March 2005 08:22
		That's what I used By: PakProtector on Fri, 04 March 2005 08:29
		Less ripple w/10k uF By: colinhester on Fri, 04 March 2005 08:47
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 09:06
		Re: Less ripple w/10k uF By: PakProtector on Fri, 04 March 2005 10:21
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 11:15
		Is cap size worth increasing in heater PS? By: colinhester on Fri, 04 March 2005 13:18
		Re: Is cap size worth increasing in heater PS? By: Manualblock on Fri, 04 March 2005 13:35
		Up and running w/ about 15 hours on the pre By: colinhester on Fri, 04 March 2005 13:43

Previous Topic:	Mounting Coupling caps
Next Topic:	More amp design considerations

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jun 06 17:07:00 CDT 2024