AudioRoundTable.com: Group Build

Home » Audio » Group Build » Filament Caps

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

That's what I used [message #30815 is a reply to message #30814]

Fri, 04 March 2005 08:29

PakProtector
Messages: 935
Registered: May 2009

Illuminati (2nd Degree)

4k7 uF is aceptable, so is 10k uF. I ran a bit on the iffy side with 10k uF @ 16 V. I hope yo guys can see the risk in that. L-C filter with ~18 vac will over-voltage them in a big way if no load is applied to the filter.

10k was just as easy for me to get as 4k7. You'll be fine w/either. I keep forgetting to limit your options, and act like a dictator.

Gilligan, dreaming, promises the crowd, "this, that, and the other thing..."
regards,
Douglas

Report message to a moderator

[Message index]

		Filament Caps By: Manualblock on Fri, 04 March 2005 06:47
		That's what I used By: colinhester on Fri, 04 March 2005 08:03
		Re: That's what I used By: Manualblock on Fri, 04 March 2005 08:22
		That's what I used By: PakProtector on Fri, 04 March 2005 08:29
		Less ripple w/10k uF By: colinhester on Fri, 04 March 2005 08:47
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 09:06
		Re: Less ripple w/10k uF By: PakProtector on Fri, 04 March 2005 10:21
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 11:15
		Is cap size worth increasing in heater PS? By: colinhester on Fri, 04 March 2005 13:18
		Re: Is cap size worth increasing in heater PS? By: Manualblock on Fri, 04 March 2005 13:35
		Up and running w/ about 15 hours on the pre By: colinhester on Fri, 04 March 2005 13:43

Previous Topic:	Mounting Coupling caps
Next Topic:	More amp design considerations

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 13:08:32 CST 2024