Home » Audio » Group Build » Common cathode biasing
Common cathode biasing [message #30753] Mon, 28 February 2005 14:27
PakProtector is currently offline  PakProtector
Messages: 935
Registered: May 2009
Illuminati (2nd Degree)
Hey-Hey!!!,
I just got done plugging an RK34 into my earlier linestage. Regulated B+ with VR tubes and DN2540 CCS plate loads.

The RK34 is a double triode, with dual anode caps and a single cathode. I ran one sectio for each channel and biased the cathode with 4x red LED's run to their 20 mA limit.

It is a nice looking valve ST shaped and ~816 sized. UX7 base. I was worried on an intellectual level at running both channels through a common cathode. I noticed nothing out of the ordinary. Sounds pretty good too. I was pleasantly suprised at its sonics. Neutral, like a 6SN7, yet with more body.
regards,
Douglas

 
Read Message
Previous Topic: Advice on mounting CCS
Next Topic: Guinever done
Goto Forum:
  


Current Time: Mon Nov 25 13:10:41 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest