AudioRoundTable.com: Group Build » Heater PS schematic

Home » Audio » Group Build » Heater PS schematic

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Different values than PSU simulation [message #30369 is a reply to message #30368]

Wed, 02 February 2005 15:45

Damir
Messages: 1005
Registered: May 2009

Illuminati (2nd Degree)

Just checked in "Circuit Maker", and get 14V with 1&2 Ohms, but I don`t have the concrete trafo data (winding resistances), and 1&2 Ohms are probably OK, but I noticed little riple, not presented in larger R / larger C version... However, those are little diffrences and can be tweaked in the "breadbording" phase...

Report message to a moderator

[Message index]

		Heater PS schematic By: Damir on Wed, 02 February 2005 15:06
		Re: Heater PS schematic By: Manualblock on Wed, 02 February 2005 15:12
		Re: Heater PS schematic By: Damir on Wed, 02 February 2005 15:23
		Re: Heater PS schematic some more By: Damir on Wed, 02 February 2005 15:14
		Different values than PSU simulation By: colinhester on Wed, 02 February 2005 15:31
		Re: Different values than PSU simulation By: Damir on Wed, 02 February 2005 15:45
		Re: Different values than PSU simulation By: colinhester on Wed, 02 February 2005 16:11
		they were a guess By: PakProtector on Wed, 02 February 2005 16:27
		Re: they were a guess By: colinhester on Wed, 02 February 2005 16:43
		Re: Different values than PSU simulation By: Manualblock on Wed, 02 February 2005 19:04

Previous Topic:	LED values?
Next Topic:	Stoetkit arrived!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 03 21:33:18 CST 2024