Home » Audio » Group Build » Here's Guinevere
Re: Here's Guinevere [message #30070 is a reply to message #30068] Wed, 29 December 2004 15:30 Go to previous messageGo to previous message
Damir is currently offline  Damir
Messages: 1005
Registered: May 2009
Illuminati (2nd Degree)
Then, IMO it is best to substitute pot with discrete resistor(s). Add a grid stopper resistor, and maybe an additional gread leak. B+ will be about 200V, and Uak~100V-110V. Two cheap red LED in series, and bias voltage Ugk will be about 3,4 - 4V. Ia=15mA seems fine. But, anode of the LED (longer lead) must go to the tube cathode, and cathode of the LED(shorter lead) to the ground. When we reach the final design, I can PC-draw it and send.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Tranny Order
Next Topic: Potentiometer
Goto Forum:
  


Current Time: Fri Nov 29 22:06:15 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest