AudioRoundTable.com: Group Build » Is there a consensus on preamp project?

Home » Audio » Group Build » Is there a consensus on preamp project?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

rectifier valves... [message #30050 is a reply to message #30047]

Sun, 26 December 2004 16:21

PakProtector
Messages: 935
Registered: May 2009

Illuminati (2nd Degree)

Hey-hey!!!, if a suitable supply is made for 2.4A of 6.3 volt filaments, a full bridge can be made from a pair of 7X6 twin diodes. Seperate cathodes and adequate PIV rating for the job at hand. Even the 261G6 is only rated for 2.5A of 6.3, increasing this is a leap up in cost...
regards,
Douglas

Report message to a moderator

[Message index]

		Is there a consensus on preamp project? By: colinhester on Fri, 24 December 2004 13:19
		consensus? By: PakProtector on Fri, 24 December 2004 19:27
		Re: consensus? By: colinhester on Fri, 24 December 2004 19:32
		Re: consensus? By: Manualblock on Fri, 24 December 2004 21:35
		some PS stuff... By: PakProtector on Sat, 25 December 2004 05:26
		Re: some PS stuff... By: Wayne Parham on Sat, 25 December 2004 08:23
		Re: some PS stuff... By: PakProtector on Sat, 25 December 2004 09:10
		Re: some PS stuff... By: Wayne Parham on Sat, 25 December 2004 09:36
		Re: some PS stuff... By: Manualblock on Sat, 25 December 2004 11:07
		rectifier valves... By: PakProtector on Sun, 26 December 2004 16:21
		Re: rectifier valves... By: Wayne Parham on Sun, 26 December 2004 16:55
		correction... By: PakProtector on Sun, 26 December 2004 18:39
		Re: rectifier valves... By: Manualblock on Sun, 26 December 2004 18:53
		Damper diodes By: PakProtector on Sun, 26 December 2004 20:27
		Re: Damper diodes By: Wayne Parham on Tue, 28 December 2004 15:32
		there's lots of choices... By: PakProtector on Wed, 29 December 2004 18:37

Previous Topic:	Project idea: Plug and Play
Next Topic:	now for an amp...

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 04 13:54:56 CST 2024