AudioRoundTable.com: Craftsmen

Home » Audio » Craftsmen » Trimming veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Downshear flush trim bit [message #29915 is a reply to message #29913]

Sun, 23 September 2007 11:53

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

This is what I use being very careful not to nick the adjacent panel. Blue taping that panel the bearing rides on helps and leaves just a whisker to trim off with sandpaper for unbacked or a scary sharp block plane for paper backed, then sand.

Report message to a moderator

[Message index]

		Trimming veneer By: colinhester on Tue, 11 September 2007 08:29
		Re: Trimming veneer By: Bob Brines on Tue, 11 September 2007 16:56
		Re: Trimming veneer By: colinhester on Wed, 19 September 2007 20:09
		Re: Downshear flush trim bit By: Bill Epstein on Sun, 23 September 2007 11:53
		Re: Downshear flush trim bit By: DaBase on Wed, 24 February 2010 22:03

Previous Topic:	Nitrocellulose
Next Topic:	Need to find a cabinet refinisher

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 04:56:24 CST 2024