Home » Audio » Craftsmen » Hand drill has a stuck chuck
Hand drill has a stuck chuck [message #29806] Sun, 15 October 2006 12:05 Go to previous message
lon is currently offline  lon
Messages: 760
Registered: May 2009
Illuminati (2nd Degree)
Years a go I got a used Craftsman reversible power drill.

The chuck 'teeth' are worn down from using it as a hole saw
and I normally remove the chuck to put a drill guide on it.

These days I can't get the chuck out to repair or replace
the head.

The usual tapping of the chuck key on the opposite side
with a mallet doesn't work anymore. It's stuck.


My directions for the drill guide say that the owners manual
for a reversible drill has the answer to this, but I have
none.

Any clues on this besides the chuck key tapping trick?

Perhaps I had the forward/reverse switch set incorrectly.

In any case I can't fix it without maybe going to Sears.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Interconnects
Next Topic: Newbee Tools
Goto Forum:
  


Current Time: Mon Nov 11 08:52:15 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest