AudioRoundTable.com: Craftsmen » Conical horn project

Home » Audio » Craftsmen » Conical horn project

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Conical horn project [message #29712 is a reply to message #29711]

Sun, 01 January 2006 03:09

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

Mount the router to a piece of plywood or MDF for a temp router table. Cut a jig with the 22.5 angle large enough to be stable as it moves along the table. Use double-face tape to hold the workpiece to the jig. Yup. It really works!
SAme can be done with the tablesaw up against the rip fence or build a cross-cut sled.

Cross Cut Sled

Report message to a moderator

[Message index]

		Conical horn project By: PakProtector on Sat, 31 December 2005 15:47
		Re: Conical horn project By: Bill Epstein on Sun, 01 January 2006 03:09
		Re: Conical horn project By: GarMan on Thu, 05 January 2006 08:19

Previous Topic:	So you want some expensive cone feet?
Next Topic:	Bonding metal to wood

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 04:56:52 CST 2024