AudioRoundTable.com: Craftsmen » Solid State vs Vacuum Tube Finish

Home » Audio » Craftsmen » Solid State vs Vacuum Tube Finish

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Only if I can wipe it on [message #29607 is a reply to message #29602]

Mon, 12 September 2005 21:14

Shane
Messages: 1117
Registered: May 2009

Illuminati (3rd Degree)

I'm telling ya, just spray a light coat of the same type of poly (gloss on gloss) a few minutes after you've brushed on a coat and it will smooth it right out. On the other hand, I like wipe-on too, because I tend to put the brush-on stuff on too thick===runs.

Report message to a moderator

[Message index]

		Solid State vs Vacuum Tube Finish By: GarMan on Fri, 09 September 2005 11:49
		Re: Amen, Brother Gar, except..... By: Bill Epstein on Fri, 09 September 2005 16:53
		I love Wipe-On By: GarMan on Sat, 10 September 2005 17:13
		Re: layering poly By: Shane on Sat, 10 September 2005 19:11
		Re: Solid State vs Vacuum Tube Finish By: Bill Martinelli on Sat, 10 September 2005 20:51
		Only if I can wipe it on By: GarMan on Mon, 12 September 2005 08:21
		Re: Only if I can wipe it on By: Shane on Mon, 12 September 2005 21:14
		Re: try this.... Wipe on is for martha stewart By: Bill Martinelli on Tue, 13 September 2005 22:13
		Re: try this.... Wipe on is for martha stewart By: GarMan on Wed, 14 September 2005 12:25

Previous Topic:	PI four enclosure
Next Topic:	Tuba18 Sub

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 03:51:03 CST 2024