AudioRoundTable.com: Craftsmen » Solid State vs Vacuum Tube Finish

Home » Audio » Craftsmen » Solid State vs Vacuum Tube Finish

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Solid State vs Vacuum Tube Finish [message #29598 is a reply to message #29594]

Sat, 10 September 2005 20:51

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

You should give Varnish a try some time.
You can use tung oil and let it cure for a few days, then use 3 coats of varnish. make sure to sand between coats because varnish will not burn in like a lacquer.

Report message to a moderator

[Message index]

		Solid State vs Vacuum Tube Finish By: GarMan on Fri, 09 September 2005 11:49
		Re: Amen, Brother Gar, except..... By: Bill Epstein on Fri, 09 September 2005 16:53
		I love Wipe-On By: GarMan on Sat, 10 September 2005 17:13
		Re: layering poly By: Shane on Sat, 10 September 2005 19:11
		Re: Solid State vs Vacuum Tube Finish By: Bill Martinelli on Sat, 10 September 2005 20:51
		Only if I can wipe it on By: GarMan on Mon, 12 September 2005 08:21
		Re: Only if I can wipe it on By: Shane on Mon, 12 September 2005 21:14
		Re: try this.... Wipe on is for martha stewart By: Bill Martinelli on Tue, 13 September 2005 22:13
		Re: try this.... Wipe on is for martha stewart By: GarMan on Wed, 14 September 2005 12:25

Previous Topic:	PI four enclosure
Next Topic:	Tuba18 Sub

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 03 01:27:14 CDT 2024