AudioRoundTable.com: Craftsmen » Back to square one, so to speak

Home » Audio » Craftsmen » Back to square one, so to speak

Thu, 02 September 2004 23:18

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

I've always enjoyed those intimate times where the drill motor has your hand pinned against a joist and it's difficult to release the trigger.....

When you think about it. The mighty right anglers are made to drill in hard to get at areas, you aren't supposed to be there!

		Back to square one, so to speak By: lon on Sun, 29 August 2004 14:42
		Re: Back to square one, so to speak By: Bill Fitzmaurice on Mon, 30 August 2004 06:16
		Re: Back to square one, so to speak By: lon on Mon, 30 August 2004 09:43
		Re: Back to square one, so to speak By: Bill Fitzmaurice on Mon, 30 August 2004 10:48
		Re: Back to square one, so to speak By: wunhuanglo on Mon, 30 August 2004 19:33
		Re: Back to square one, so to speak By: lon on Mon, 30 August 2004 21:36
		Milwaukee drill By: wunhuanglo on Thu, 02 September 2004 19:43
		Re: Milwaukee drill By: Bill Martinelli on Thu, 02 September 2004 23:18
		Re: Milwaukee drill and better alternatives By: lon on Fri, 03 September 2004 14:32
		Re: Hey Bill, can you just cut a slot? By: The Auntie-Polly on Mon, 30 August 2004 16:32
		Re: Hey Bill, can you just cut a slot? By: Bill Fitzmaurice on Tue, 31 August 2004 06:24
		Re: Back to square one, so to speak By: colinhester on Mon, 30 August 2004 13:48
		Re: Back to square one, so to speak By: Jeff Robinson on Wed, 01 September 2004 08:23
		Re: Back to square one, so to speak By: colinhester on Wed, 01 September 2004 09:15
		Confucious say you get what you pay for... By: Bill Fitzmaurice on Thu, 02 September 2004 06:41

Previous Topic:	Other plywood tricks
Next Topic:	No table saw? No problem - build a sawboard

Goto Forum:

] [

]

Current Time: Thu Nov 21 21:32:53 CST 2024