AudioRoundTable.com: Craftsmen » Back to square one, so to speak

Home » Audio » Craftsmen » Back to square one, so to speak

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Back to square one, so to speak [message #29241 is a reply to message #29237]

Mon, 30 August 2004 13:48

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Again, Check out Harbor Freight (http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=44506) for a pretty inexpensive drill press. If there's one in your area, be sure to sign up on line for discount coupons (5% for $50 and 10% over $100.) Also, I would check out the local paper for deals or garage sales. Drill presses are pretty easy to come by, and I think it would save you a world of frustration......Colin

Report message to a moderator

[Message index]

		Back to square one, so to speak By: lon on Sun, 29 August 2004 14:42
		Re: Back to square one, so to speak By: Bill Fitzmaurice on Mon, 30 August 2004 06:16
		Re: Back to square one, so to speak By: lon on Mon, 30 August 2004 09:43
		Re: Back to square one, so to speak By: Bill Fitzmaurice on Mon, 30 August 2004 10:48
		Re: Back to square one, so to speak By: wunhuanglo on Mon, 30 August 2004 19:33
		Re: Back to square one, so to speak By: lon on Mon, 30 August 2004 21:36
		Milwaukee drill By: wunhuanglo on Thu, 02 September 2004 19:43
		Re: Milwaukee drill By: Bill Martinelli on Thu, 02 September 2004 23:18
		Re: Milwaukee drill and better alternatives By: lon on Fri, 03 September 2004 14:32
		Re: Hey Bill, can you just cut a slot? By: The Auntie-Polly on Mon, 30 August 2004 16:32
		Re: Hey Bill, can you just cut a slot? By: Bill Fitzmaurice on Tue, 31 August 2004 06:24
		Re: Back to square one, so to speak By: colinhester on Mon, 30 August 2004 13:48
		Re: Back to square one, so to speak By: Jeff Robinson on Wed, 01 September 2004 08:23
		Re: Back to square one, so to speak By: colinhester on Wed, 01 September 2004 09:15
		Confucious say you get what you pay for... By: Bill Fitzmaurice on Thu, 02 September 2004 06:41

Previous Topic:	Other plywood tricks
Next Topic:	No table saw? No problem - build a sawboard

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 19:18:07 CST 2024