AudioRoundTable.com: Craftsmen » Using a fly cutter

Home » Audio » Craftsmen » Using a fly cutter

Wed, 25 August 2004 11:58

lon
Messages: 760
Registered: May 2009

Illuminati (2nd Degree)

I tried that first... plain 1/4 drill. Too short.
Not waaay too short but short. Even the special
center bit is not very long.

		Using a fly cutter By: lon on Sat, 21 August 2004 11:05
		Re: Using a fly cutter By: wunhuanglo on Sat, 21 August 2004 14:52
		Re: Using a fly cutter ( should be hole saw) By: lon on Sat, 21 August 2004 15:32
		Re: Using a fly cutter ( should be hole saw) By: wunhuanglo on Wed, 25 August 2004 04:57
		Re: Using a fly cutter ( should be hole saw) By: lon on Wed, 25 August 2004 11:58

Previous Topic:	Quick poll: what would you veneer with out of these?
Next Topic:	Other plywood tricks

Goto Forum:

] [

]

Current Time: Mon Nov 25 09:03:14 CST 2024