AudioRoundTable.com: Craftsmen

Home » Audio » Craftsmen » Veneer finishing

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Veneer finishing [message #28883 is a reply to message #28881]

Sat, 20 December 2003 04:57

Adrian Mack
Messages: 568
Registered: May 2009

Illuminati (1st Degree)

I think its decided then, Tung oil is the way to go! Is this an expensive finish? I lacquered a shelving cabinet I made before, but the pictures of "elektratig's" Tempest sub with Tung oil looked real good, way better than the laquer I used.

Adrian

Report message to a moderator

[Message index]

		Veneer finishing By: Adrian Mack on Fri, 19 December 2003 00:08
		Re: Ask the Other Bill By: BillEpstein on Fri, 19 December 2003 05:07
		I'm New at this but . . . By: elektratig on Fri, 19 December 2003 12:00
		Re: I'm New at this but . . . By: Adrian Mack on Sat, 20 December 2003 04:59
		Re: Veneer finishing By: Bill Martinelli on Fri, 19 December 2003 18:52
		Re: Tell, Tell! nt By: BillEpstein on Fri, 19 December 2003 20:54
		Re: Veneer finishing By: Adrian Mack on Sat, 20 December 2003 04:57
		Re: Veneer finishing By: billfort on Sat, 27 December 2003 20:23
		Re: Veneer finishing By: Adrian Mack on Sat, 27 December 2003 21:47

Previous Topic:	Lacquer Finish, a few ideas to get you started
Next Topic:	Cabinet finishing

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Feb 16 13:43:06 CST 2025