AudioRoundTable.com: General » Help ID'ing wires on Fisher Mono Tube Receiver

Home » Audio » General » Help ID'ing wires on Fisher Mono Tube Receiver

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Help ID'ing wires on Fisher Mono Tube Receiver [message #26654 is a reply to message #26653]

Tue, 09 October 2007 14:48

Dinchart2
Messages: 3
Registered: May 2009

Esquire

Thanks. The question is, can I connect just the yellow and black wires into a regular speaker (this is a mono setup) and tape off the other wires, or would you think the amplifier needs to sense that all the wires are connected?

Report message to a moderator

[Message index]

		Help ID'ing wires on Fisher Mono Tube Receiver By: Dinchart2 on Sun, 07 October 2007 18:55
		Re: Help ID'ing wires on Fisher Mono Tube Receiver By: Wayne Parham on Mon, 08 October 2007 09:00
		Re: Help ID'ing wires on Fisher Mono Tube Receiver By: Dinchart2 on Mon, 08 October 2007 21:15
		Re: Help ID'ing wires on Fisher Mono Tube Receiver By: Wayne Parham on Tue, 09 October 2007 12:59
		Re: Help ID'ing wires on Fisher Mono Tube Receiver By: Dinchart2 on Tue, 09 October 2007 14:48
		Re: Help ID'ing wires on Fisher Mono Tube Receiver By: Wayne Parham on Tue, 09 October 2007 20:16

Previous Topic:	New speaker at Rocky Mountain Audio Fest
Next Topic:	ART Search Engine

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 23 04:28:52 CST 2024