Home » Audio » Room Acoustics » SPL meter confusion (long)
DIY Microphone Boom [message #24992 is a reply to message #24991] Fri, 26 December 2003 09:26 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18792
Registered: January 2001
Illuminati (33rd Degree)
You can make a nice little measurement boom with an inexpensive plastic tube available at most hardware and plumbing supply stores.

The tube used for plumbing the cold water supply to a toilet is available in plastic, and it's the perfect size for fitting the Panasonic condensor microphones, including the WM-60AY. These tubes are about 20" (1/2 meter) long and work very well for this purpose. You can pick them up at just about any hardware supply store.

The capsule can be pressed in and it fits in snugly. Run a shielded microphone cable up through the tube and solder it to the tabs on the microphone so that the solder joints do not extend wider than the diameter of the capsule. Press the microphone down into the tube a little bit so that it is held firmly.

This makes a neat little measurement boom. One end is the microphone and boom, and the other end is shielded cable to RCA plug.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Room gain AKA cabin gain
Next Topic: Room Acoustics
Goto Forum:
  


Current Time: Mon Dec 02 19:29:23 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest