Home » Audio » Speaker » acoustat renewal
Re: acoustat renewal [message #24720 is a reply to message #24714] Mon, 04 July 2005 21:55 Go to previous message
moray james is currently offline  moray james
Messages: 51
Registered: May 2009
Baron
Kevin: first off I would suggest you get two 50uF Blackgate caps and place them at the input (replace the big BP electrolytic with it's bypass caps). Second I would suggest you get a bunch of the largest value carbon resistors and make two new 20 Meg ohm load resistors. Slide the string of resistors into a flexible plastic tube. This will allow you to replace the 500 meg ohm load resistors in the high voltage supply. Next I would suggest that you get twenty surplus 1 Henry chokes and string ten together, spaced on a support wire them in series and then place this composite choke in series with the high voltage supply after the load resistor. Then I would suggest that you reshrink your diaphragms to retension the mylar and remove any wrinkles. After all of this there is still more that can be done but you will have done the major improvements and be very amazed at how good your 0ne plus 0nes can sound. Have fun best regards Moray James.

 
Read Message
Read Message
Previous Topic: CSS FR125s thoughts...
Next Topic: New Pic & Observations
Goto Forum:
  


Current Time: Sun Jul 07 12:55:20 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest