AudioRoundTable.com: Speaker » Any interest in a diy esl project?

Home » Audio » Speaker » Any interest in a diy esl project?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Any interest in a diy esl project? [message #24688 is a reply to message #24686]

Wed, 25 May 2005 16:16

Jerry Kinzel
Messages: 5
Registered: May 2009

Esquire

Thanks for the information Moray, greatly appreciated. I plan on using a mechanical woofer, probably crossing over at 400-500 Hz. I am still tempted to try slighlty curved stators, perhaps on the order of 15 degrees. Anyone have any thoughts or experiences? I don't want to kill imaging, but also don't want the "head in vise" either. All thoughts and suggestions welcome. By the way, to make electrical contact with the diaphram, I found 1/4 inch wide, 1 mil. thick copper adhesive backed tape on e-bay under stained glass accessories. Cost was less than $7, including shipping.

Report message to a moderator

[Message index]

		Any interest in a diy esl project? By: moray james on Tue, 24 May 2005 18:55
		Re: Any interest in a diy esl project? By: Jerry Kinzel on Tue, 24 May 2005 20:44
		Re: Any interest in a diy esl project? By: moray james on Wed, 25 May 2005 11:44
		Re: Any interest in a diy esl project? By: moray james on Wed, 25 May 2005 17:08
		Re: Any interest in a diy esl project? By: Jerry Kinzel on Wed, 25 May 2005 17:55
		Re: Any interest in a diy esl project? By: Jerry Kinzel on Wed, 25 May 2005 16:16
		Re: Any interest in a diy esl project? By: sam9 on Fri, 01 July 2005 14:33

Previous Topic:	What are these called?
Next Topic:	The BEAST is here????

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 29 18:09:00 CDT 2024