Home » Audio » Speaker » Building an RS8.
Building a a set of Calipso's [message #24162 is a reply to message #24161] Sat, 09 February 2008 19:36 Go to previous messageGo to previous message
Marlboro
Messages: 403
Registered: May 2009
Illuminati (1st Degree)
I use a three way system: Per channel: 30 dome tweeters cut to a c-to-c distance of about .86 inch, 17 -3.5 inch 3 mm x-max midranges covering the 165hz to 2400hz frequency range, and and 1 -12 inch poly Prop 15 mm x-max 250 watt DVC woofer covering about 20hz to 165hz. The crossover is an analog Rane Ac-23b electronic crossover, 24 db/octave.

The woofers are powered by their own 350 w/ch amp, the mids by their own 175 w/ch amp, and the tweeters by their own 60w/ch amp. Each amp has its own volume controls, so i can limit the amount of volume control that is required by the Rane unit

Each midrange speaker is inside its own completely separate 4 x 23.5 inch tubular enclosure(1/2 outside air space between them), stuffed with 4 lb/cu ft fiberglas wrapped in polyfill batting.

The woofers are in their own slightly small ported enclosure, but the room acoustics compensate, and with the power available to them put out more bass than I need at any music I listen to, and provide plenty of punch I can feel in my gut if I'm so inclined(as I just felt in David Sanborn's STRAIGHT TO THE HEART album.

Marlboro

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Power Taper
Next Topic: lobing in dome tweeters destroying high's
Goto Forum:
  


Current Time: Wed Jul 17 16:46:39 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest