Home » Audio » Speaker » DCX crossover installed
Re: DCX crossover installed [message #23854 is a reply to message #23846] Sun, 08 July 2007 17:33 Go to previous messageGo to previous message
Rick Craig is currently offline  Rick Craig
Messages: 115
Registered: May 2009
Viscount
JP,

If you don't apply any baffle step compensation then the speakers will sound too forward and thin in the lower midrange. If you're setting your microphone at the listening position you should shelve slightly downward the response above 200hz. The amount of tilt will depend on your room and listening preference.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: JBL 2225H reconed as a 2235H?
Next Topic: JBL G-730 Diaphragm quest
Goto Forum:
  


Current Time: Sat Nov 23 18:28:11 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest