I am NOT against inexpensive solutions to stuff, and think there are low cost drivers thhat have been overloked that will perform well.

I like how you cut the faceplates on your tweeters.

I BET that array sounds nice!

I have these VMPS RM 40 speakers that I am TRYING to make work for me.

The woofers cross at 200 hz right now in mine at 6 db per octave.

I am stuck with the 54 inch spacing.

Just for kicks, I might simply unhook the stock crossover, leaving the tweeter crossover, and bi amp them with the Rane ?

Then, I could simply move the crossover point up and down till they sound better ?

In the stock RM 40, the two 10 inch drivers roll off at different points.

Right now, I have two of the same woofers in each one, and their roll off is the same.