Home » Audio » Speaker » ART Arrays for HT?
ART Arrays for HT? [message #23597] Sun, 01 April 2007 14:31 Go to previous message
Rich_M9999 is currently offline  Rich_M9999
Messages: 15
Registered: May 2009
Chancellor
Hello,

I'm new to this forum but have been reading the posts for some time. I have what may or may not be a silly question.

I have seen where the ART arrays are tube amp friendly, but I would be driving them with a Yamaha AV 5.1 receiver that is rated 6 ohm stable. Is it possible to use these beautiful speakers for this application? My room is 14' ft wide and 40' ft long (due to an open plan through small DR and into kitchen). my listening position is approximately 18' from TV that is mounted over fireplace. I have cathedral ceiling that is 8.5' on sidewall up to 10.5' at the other side of the room. (so, it is rather large).I use this system for about 60/40 TV over music. I think these arrays would fill the listening room quite nicely, provided I can drive them with this amp. Any advice or help here is deeply appreciated.
Thanks,
Rich

 
Read Message
Read Message
Read Message
Previous Topic: High frequency dispersion and driver size
Next Topic: Enclosure construction
Goto Forum:
  


Current Time: Fri Nov 29 19:03:21 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest