AudioRoundTable.com: Speaker » New Cheap Quasi Line Array

Home » Audio » Speaker » New Cheap Quasi Line Array

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Woofer Array Crossover Frequency Limitations [message #22860 is a reply to message #22859]

Wed, 30 November 2005 11:22

FredT
Messages: 704
Registered: May 2009

Illuminati (1st Degree)

Woofer arrays must be crossed over a fairly low frequencies because of the comb effect above the frequency where the driver starts beaming. I'll refer you to Jim Griffin's nearfield line array white paper for an explanation. See the section on center-to-center driver separation for circular drivers starting on page eleven.

Nearfield Line Array White Paper

Report message to a moderator

[Message index]

		New Cheap Quasi Line Array By: FredT on Tue, 29 November 2005 08:42
		Re: New Cheap Quasi Line Array By: Wayne Parham on Tue, 29 November 2005 09:01
		Re: New Cheap Quasi Line Array By: Mike T. on Tue, 29 November 2005 10:44
		Re: New Cheap Quasi Line Array By: Tom R. on Tue, 29 November 2005 12:21
		My Advice About DIY Line Arrays By: FredT on Tue, 29 November 2005 14:31
		Re: My Advice About DIY Line Arrays By: Tom R. on Wed, 30 November 2005 09:54
		Woofer Array Crossover Frequency Limitations By: FredT on Wed, 30 November 2005 11:22
		Re: Woofer Array Crossover Frequency Limitations By: Tom R. on Wed, 30 November 2005 12:11
		Array driver response By: Bill Fitzmaurice on Fri, 09 December 2005 08:33
		Re: My Advice About DIY Line Arrays By: Anonymous on Wed, 30 November 2005 11:43
		NSB/PT2 Line Array By: FredT on Wed, 30 November 2005 12:34
		Another Thought By: FredT on Thu, 01 December 2005 06:23
		Re: Another Thought By: Renato on Mon, 05 December 2005 16:45
		Re: New Cheap Quasi Line Array By: scoolman on Thu, 19 January 2006 04:58

Previous Topic:	Any thoughts on this driver?
Next Topic:	Interesting quote

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Aug 08 14:21:58 CDT 2024