AudioRoundTable.com: Speaker » When tapering not needed

Home » Audio » Speaker » When tapering not needed

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Jim, tweeters are working... [message #22802 is a reply to message #22800]

Tue, 30 August 2005 01:21

skaloumbakas
Messages: 11
Registered: May 2009

Chancellor

Thanks Jim,

I think the crossover point for the tweeters line array is at 7000 Hz, but they start working at around 4500 Hz, due to the crossover slope (I think - I am not an expert in electronics).

So, is it worth it?

Christos

Report message to a moderator

[Message index]

		When tapering not needed By: Eric J on Tue, 16 August 2005 15:50
		Re: When tapering not needed By: Jim Griffin on Tue, 16 August 2005 18:40
		Thanks By: eric j. Uberseder on Tue, 16 August 2005 18:42
		Re: When tapering not needed By: Bill Wassilak on Thu, 25 August 2005 09:44
		Re: When tapering not needed By: Jim Griffin on Fri, 26 August 2005 06:42
		12 twt's with 48 inch length need tapering or not? By: skaloumbakas on Fri, 26 August 2005 13:28
		Re: 12 twt's with 48 inch length need tapering or not? By: Wayne Parham on Sat, 27 August 2005 01:23
		thanks By: skaloumbakas on Sat, 27 August 2005 23:44
		Re: thanks By: Wayne Parham on Sun, 28 August 2005 02:06
		Re: 12 twt's with 48 inch length need tapering or not? By: Jim Griffin on Sun, 28 August 2005 21:11
		Jim, tweeters are working... By: skaloumbakas on Tue, 30 August 2005 01:21

Previous Topic:	Ping "Ed"
Next Topic:	lowther drivers in cabinets

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Aug 14 17:17:37 CDT 2024