AudioRoundTable.com: Speaker » compression horn tweeter

Home » Audio » Speaker » compression horn tweeter

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: It won't work. [message #22176 is a reply to message #22175]

Wed, 28 July 2004 14:11

mike erb
Messages: 9
Registered: May 2009

Esquire

thanks ,is it the 80" length or the small width ?,i've been looking at car audio softdome tweeters can buy them wholesale for $1.50 a set
also ,what size mids do you think are the best ,can use 16 each 5.25" or 18 each 4.5" or 24 each 3.5" all cheap though parts express closeout sale ,also do i need to have a bass blocker and at what frequency like 80hz or higher like 120hz? and do that many drivers wired series/parallel change your crossover points ,sould i bi-amp or not also thought about an electronic crossover ,this would only work if i bi-amp'd ofcourse.this is going to be a 7.1 surround system the three fronts left ,right ,center will be the only line array speakers ,thought this infomation may help.thanks

Report message to a moderator

[Message index]

		compression horn tweeter By: mike erb on Tue, 27 July 2004 21:43
		It won't work. By: Bill Fitzmaurice on Wed, 28 July 2004 13:45
		Re: It won't work. By: mike erb on Wed, 28 July 2004 14:11
		Re: It won't work. By: Bill Fitzmaurice on Wed, 28 July 2004 14:57
		Re: It won't work. By: mike erb on Wed, 28 July 2004 15:29
		Re: It won't work. By: Bill Fitzmaurice on Thu, 29 July 2004 05:38
		Re: It won't work. By: mike erb on Thu, 29 July 2004 10:34
		Re: It won't work. By: Bill Fitzmaurice on Thu, 29 July 2004 11:56
		Re: It won't work. By: mike erb on Thu, 29 July 2004 12:19
		Re: It won't work. By: Bill Fitzmaurice on Fri, 30 July 2004 07:01
		Re:box shape By: mike erb on Sat, 31 July 2004 16:38
		Re:box shape By: Bill Fitzmaurice on Sat, 31 July 2004 19:43
		Re:box shape By: mike erb on Sat, 31 July 2004 20:13
		Driver T/S Specs By: Bill Fitzmaurice on Sun, 01 August 2004 07:49

Previous Topic:	new DIY speaker
Next Topic:	Taking a wild guess here about cross-over design

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Aug 13 01:52:05 CDT 2024