AudioRoundTable.com: Speaker » Adding Tweeter to Full Range Driver

Home » Audio » Speaker » Adding Tweeter to Full Range Driver

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Adding Tweeter to Full Range Driver [message #21783 is a reply to message #21781]

Fri, 02 March 2007 21:50

Bill Wassilk
Messages: 19
Registered: May 2009

Chancellor

I agree with everything Duke said. It's been a while since I've listened to the Fostex Fe167. I forget what model of Fostex's it was, but it was one of the smaller FE series seemed like it started going cone breakup mode, or rolling of between 6k-8k, but people were x-over betweem 8k-10k with just a cap to add the extra high-end extension. Jim Denton or Akhilesh should chime in, they've used Fostex's in the past.
Bill W.

P.S. The Fostex FE206E is one of the smoothest single drivers I've heard.

Report message to a moderator

[Message index]

		Adding Tweeter to Full Range Driver By: ttan98 on Thu, 01 March 2007 19:40
		Re: Adding Tweeter to Full Range Driver By: Duke on Fri, 02 March 2007 19:04
		Re: Adding Tweeter to Full Range Driver By: Bill Wassilk on Fri, 02 March 2007 21:50
		Dagogo review By: colinhester on Sat, 03 March 2007 19:16
		Re: Adding Tweeter to Full Range Driver By: akhilesh on Sun, 04 March 2007 10:58
		Re: Adding Tweeter to Full Range Driver By: ttan98 on Mon, 05 March 2007 15:57

Previous Topic:	1:1 throat area
Next Topic:	Crossover Cap Comparison

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 10 20:14:21 CDT 2024