Home » Audio » Speaker » A little article about a BLH....why go to the trouble.....
Mouth Area and Cut-Off Frequency [message #21251 is a reply to message #21240] Sat, 20 August 2005 14:16 Go to previous messageGo to previous message
Martin is currently offline  Martin
Messages: 220
Registered: May 2009
Master
For your mouth area, and assuming only floor reinforcement, I get a lower cut-off frequency of 172.5 Hz. The only way I can get your 86Hz is if I assume the speaker is flush against a side wall also. My guess is that your Hedlund horn is really acting like a TL below 200 Hz and transitions to a horn above this frequency.

I would also speculate that you are probably getting weak bass and could use a BSC circuit to help tame the rising mid and high frequency response of the DX4 driver, this is probably why you are using a sub woofer to help the low end. With a good BSC circuit design, the sub woofer may not always be needed unless you really want to play bass heavy music.

Martin

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Array with Aurum G1 and Extremis?
Next Topic: Bass horn pic
Goto Forum:
  


Current Time: Fri Nov 15 20:38:03 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest