AudioRoundTable.com: Speaker » voight pipe plans for 206 Fostex

Home » Audio » Speaker » voight pipe plans for 206 Fostex

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: voight pipe plans for 206 Fostex [message #20897 is a reply to message #20896]

Mon, 09 May 2005 11:03

FredT
Messages: 704
Registered: May 2009

Illuminati (1st Degree)

The only plan I have seen is at the link below. It seems to be about the same size as your current pipes. It uses the 207 instead of the 206. I have been considering building another set of Voigt pipes for my Audio Nirvana 8" drivers, whose T/S parameters are close to the 206. I will make them in a slightly larger cross section, dictated by the 11-1/4" width of the mdf boards I get from my lumber source. But hardwood would look really nice.

Voigt Pipes for 8" Fostex Drivers

Report message to a moderator

[Message index]

		voight pipe plans for 206 Fostex By: jim denton on Mon, 09 May 2005 10:14
		Re: voight pipe plans for 206 Fostex By: FredT on Mon, 09 May 2005 11:03
		Re: voight pipe plans for 206 Fostex By: roncla on Mon, 09 May 2005 16:54
		Good Thing to Know By: FredT on Mon, 09 May 2005 18:03
		Re: Good Thing to Know By: Bob Brines on Mon, 09 May 2005 20:50
		Opinions on Voigt Pipe By: GarMan on Tue, 10 May 2005 12:51
		Re: Opinions on Voigt Pipe By: Bob Brines on Tue, 10 May 2005 14:10
		Re: Opinions on Voigt Pipe By: roncla on Fri, 13 May 2005 18:51
		Re: voight pipe plans for 206 Fostex By: zobsky on Tue, 10 May 2005 14:18
		Re: voight pipe plans for 206 Fostex By: jim denton on Wed, 11 May 2005 08:25
		Voigt Pipe Alternative for FE-206 By: FredT on Tue, 10 May 2005 19:43
		Re: voight pipe plans for 206 Fostex By: james_b on Sun, 26 June 2005 09:01

Previous Topic:	Deep Model 16 Loudpeaker system
Next Topic:	Component Values for ELF1.5 ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jul 11 16:18:57 CDT 2024