Home » Audio » Speaker » Speakerlab K Horn
Re: Speakerlab K Horn [message #19017 is a reply to message #19016] Sun, 17 December 2006 09:57 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)

This was described as a "rubber throat" in a paper written by Paul Klipsch in 1941 called "A low frequency horn of small dimensions". He proposes that his Klipschorn corner horn have an initial wide taper for the first eight inches corresponding to a 100Hz flare rate. The rest of the passages have a slower flare, corresponding to a 47Hz flare rate.


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: so I built these lines with a single tweeter
Next Topic: Pick the right mid/woofer
Goto Forum:
  


Current Time: Fri Nov 29 19:02:05 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest