AudioRoundTable.com: Speaker » Altec 902 / Edgarhorns: compensation experiments

Home » Audio » Speaker » Altec 902 / Edgarhorns: compensation experiments

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Series and Shunt Resistance [message #17686 is a reply to message #17675]

Mon, 28 March 2005 19:25

Floyd Andrews
Messages: 31
Registered: May 2009

Baron

Thanks, Wayne! Right after I got your message I went home and put a 25 ohm resistor in shunt before the series resistor. That value was used just because I had it on hand. You were right (as usual) Sounded much better. Now to get a few more resistors to try for an optimum combination. I'm going to try some of the values that you use in the Pi crossovers next.

Report message to a moderator

[Message index]

		Altec 902 / Edgarhorns: compensation experiments By: Floyd Andrews on Thu, 24 March 2005 17:13
		Re: Altec 902 / Edgarhorns: compensation experiments By: Wayne Parham on Thu, 24 March 2005 21:17
		Thanks, Wayne! By: Floyd Andrews on Fri, 25 March 2005 09:53
		Series and Shunt Resistance By: Wayne Parham on Fri, 25 March 2005 12:38
		Re: Series and Shunt Resistance By: spkrman57 on Sun, 27 March 2005 11:07
		Uniform DI verses Collapsing DI By: Wayne Parham on Sun, 27 March 2005 15:34
		Wish i understood everthing you said... By: spkrman57 on Tue, 29 March 2005 12:32
		Re: Directivity Index, Collapsing DI, etc. By: Wayne Parham on Tue, 29 March 2005 14:45
		I understand a little bit better now! By: spkrman57 on Wed, 30 March 2005 12:01
		Re: I understand a little bit better now! By: Wayne Parham on Wed, 30 March 2005 17:58
		Re: I understand a little bit better now! By: spkrman57 on Thu, 31 March 2005 06:35
		Re: I understand a little bit better now! By: Wayne Parham on Thu, 31 March 2005 07:10
		Re: I understand a little bit better now! By: Bill Martinelli on Thu, 31 March 2005 20:28
		Re: Directivity vs Omni-directional By: GarMan on Thu, 31 March 2005 07:39
		Uniformity By: Wayne Parham on Thu, 31 March 2005 08:07
		Re: Directivity vs Omni-directional By: Mike.e on Wed, 06 April 2005 19:58
		Re: Series and Shunt Resistance By: Floyd Andrews on Mon, 28 March 2005 19:19
		Re: Series and Shunt Resistance By: Floyd Andrews on Mon, 28 March 2005 19:25
		Re: Series and Shunt Resistance By: Wayne Parham on Mon, 28 March 2005 20:41

Previous Topic:	PHY-HP - Know anything about these?
Next Topic:	Does anybody here know how to add and subtract?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 10:41:53 CST 2024