Home » Audio » Speaker » ELECTRO-VOICE (E-V) vintage speakers
Re: ELECTRO-VOICE (E-V) vintage speakers [message #17130 is a reply to message #17129] Wed, 27 October 2004 03:03 Go to previous messageGo to previous message
Eric Mainardi is currently offline  Eric Mainardi
Messages: 22
Registered: May 2009
Chancellor
Hello PETE,

E-V T35 :
The earlier T35 version came with an ALNICO magnet, 16ohm impedance and 57dB EIA sensitivity rating.
Later (end of 60's) was introduced the T35A with 8ohm impedance and still 57dB EIA sensitivity.
In the beginning of 70's, E-V documents change EIA sensitivity to standardized sensitivity and so rated T35A with 104dB @ 1W @ 1m .
2 versions : ALNICO round magnet and later CERAMIC rectangular magnet (1978) with same given characteristics.
This is valid of course for recent speakers. Due to ageing of alnico magnets, the sensitivity of your T35s should be slightly less now, if older than let's say 10 years.
Best regards,
ERIC

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Ping: Jim Griffin - DIY Atlanta speaker
Next Topic: Looking for Great Speaker Designs (appearance only)
Goto Forum:
  


Current Time: Fri Nov 15 16:21:07 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest