Home » Audio » Speaker » Source for Altec 902 diaphragms?
Re: Source for Altec 902 diaphragms? [message #16913 is a reply to message #16902] Sat, 28 August 2004 15:39 Go to previous message
Russellc is currently offline  Russellc
Messages: 397
Registered: May 2009
Illuminati (1st Degree)
I may be mistaken, (I have both drivers but have not opened them up recently) but I don't think the "kit" is required for the 902 series.
The older 802 diapram/voice coil unit had different hookups for the incoming wires. The great plaines diapram should fit right in, but if installing in an older 802, the kit is required to convert to the more recent hookup style. Call Bill at great plains to make sure, Again, it has been a while, but I had to purchase one of those kits before for an 802.
Hopefully I haven't confused further,
Russellc

 
Read Message
Read Message
Read Message
Previous Topic: Acoustic impedance of arrays
Next Topic: Altec parts available
Goto Forum:
  


Current Time: Wed Dec 04 22:04:34 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest