Home » Audio » Speaker » Dual-driver sub basshorn plans
Throat hole [message #16546 is a reply to message #16534] Tue, 25 May 2004 08:03 Go to previous messageGo to previous message
Adrian Mack is currently offline  Adrian Mack
Messages: 568
Registered: May 2009
Illuminati (1st Degree)
> I don't think its shape or proximity to the apex are terribly
> important because the frequencies you'll be using the horn for are
> so low. Cut it round or square, whichever is easiest for you to
> do. I would position the woofer(s) near the apex and cut a hole
> for each woofer, located centrally, just over the dust cap.

Are you sure that doing a seperate hole for each woofer is OK? What you are saying makes sense, just want to make sure - I guess the horn wouldn't know where the drivers at this low freq's + close spacing.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Bill Fitzmaurice Website
Next Topic: Ferguson Hill FH 001 speaker
Goto Forum:
  


Current Time: Fri Aug 02 05:22:24 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest