Home » Audio » Speaker » First-order tweeter crossovers
Re: First-order tweeter crossovers [message #16397 is a reply to message #16388] Fri, 16 April 2004 07:14 Go to previous messageGo to previous message
hurdy_gurdyman is currently offline  hurdy_gurdyman
Messages: 416
Registered: May 2009
Illuminati (1st Degree)
I'm using a transformer coupled piezo with a first order crossover with my EV LS-12 open baffles. A 1.5uF cap couples the 25 volt line transformer used to the amp. After the transformer is a zobel circuit and a 60 ohm resistor. The piezo has liquid nails covering the cheap plastic horn and a thin coat of Dammar varnish on the diaphram. The whole thing sounds pretty good. I've been listening to this set-up instead of my Heresy's for over a week now and am in no hurry to switch again.

Dave :^)

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: LABsub Bass Horn Project
Next Topic: Piezo tweeters, crossovers, transformers, etc.
Goto Forum:
  


Current Time: Fri Nov 29 08:07:21 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest