Home » Audio » Speaker » Questions about piezo super tweet
Re: Questions about piezo super tweet [message #16111 is a reply to message #16110] Sun, 08 February 2004 14:48 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)
To attenuate the tweeters without forming a crossover, put a capacitor in series with them. If you want a resistor in shunt for amp-load purposes, then put it ahead of the capacitor. Placing a resistor directly across the tweeter connector lugs when using a series capacitor forms a first-order crossover. If you want a crossover for the tweeters, then that may be appropriate and there are many other suitable circuits too. But if you want to run 'em "crossoverless" - with mechanical rolloff at 3500Hz - then remove the shunt resistor or place it ahead of the series attenuation cap.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 30hz horn design complete.
Next Topic: Adjusting for difference in gain in biamping
Goto Forum:
  


Current Time: Sat Nov 30 06:52:32 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest