Home » Audio » Speaker » Crossover Cap Comparison
Re: Detail [message #15227 is a reply to message #15224] Wed, 01 March 2006 15:03 Go to previous messageGo to previous message
FredT is currently offline  FredT
Messages: 704
Registered: May 2009
Illuminati (1st Degree)
I kid you not, Wayne, the cap and resistor upgrade has taken these speakers to a whole new level. Do you remember my story about the Magnepan 1.6's? At a Houston Audio Society meeting we played my upgraded 1.6's side by side in an A/B comparison with another member's non-modded pair (with the stock Solen caps). The unanimous conclusion was that the modded speakers (also using Northcreek caps and resistors) were so much smoother and more detailed they didn't even sound like the same speaker. Ditto for the 3 Pi's. I had been using a Fountek ribbon as a supertweeter, but with the upgrade to the Eminence tweeter crossover the Fountek adds nothing; in fact, it actually detracts a bit.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Adding Tweeter to Full Range Driver
Next Topic: Acoustical Klein-Gordon Equation
Goto Forum:
  


Current Time: Tue Nov 26 01:39:29 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest