Home » Audio » Source » Rek-O-Kut project finished at last!
Re: Rek-O-Kut project finished at last!--The O-Ring Idler [message #13500 is a reply to message #13441] Sat, 01 September 2007 16:35 Go to previous messageGo to previous message
David Lawrence is currently offline  David Lawrence
Messages: 3
Registered: May 2009
Esquire
Hi,
Could you say anything about how you had this made? Was it a modification of a ready-made idler pulley? Did you use a sintered bronze bearing or a bushing below? What size and thickness of o-ring did you use? How much did the machine shop charge? Thanks a lot for any advice.
David

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Phono Cartridge
Next Topic: two funny sl-d2's in a row?
Goto Forum:
  


Current Time: Wed Nov 27 19:07:14 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest