Home » Audio » Source » Loosing quality
Re: Loosing quality [message #13125 is a reply to message #13124] Tue, 24 October 2006 16:16 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18786
Registered: January 2001
Illuminati (33rd Degree)

You should probably adjust the arm setup. Sounds like stylus alignment is off in some way as the stylus nears the center of the platter. Check everything out, using the information in the link below:

Report message to a moderator

[Message index]
 
Read Message
Read Message
Previous Topic: Technics 1200s audio from 1 channel only
Next Topic: Needle Suppliers
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Nov 27 07:44:00 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest