AudioRoundTable.com: Source » BSR 710: repair or replace?

Home » Audio » Source » BSR 710: repair or replace?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: BSR 710: repair or replace? [message #12152 is a reply to message #12149]

Mon, 09 May 2005 12:53

stevemilleresq
Messages: 3
Registered: May 2009

Esquire

The question is is it a decent enough (say as compared to a music hall MM-5 or similar, which is what I would replace it with) to justify repairing. I'm guessing it will would cost at least $155.00 (to "refurbish" if I sent it to the turntable factory) so that's a figure I'm keeping in my head for the least it would cost for repair. There's not much wrong with it as far as I can see, it seems that the rubber motor wheel has dried out and is slipping on the platter.

Thanks much with your help.

Report message to a moderator

[Message index]

		BSR 710: repair or replace? By: stevemilleresq on Sat, 07 May 2005 15:17
		Re: BSR 710: repair or replace? By: Manualblock on Sun, 08 May 2005 10:00
		Re: BSR 710: repair or replace? By: stevemilleresq on Mon, 09 May 2005 12:53
		Re: BSR 710: repair or replace? By: Manualblock on Mon, 09 May 2005 13:44
		Re: BSR 710: repair or replace? By: stevemilleresq on Tue, 10 May 2005 13:52
		Re: BSR 710: repair or replace? By: Manualblock on Tue, 10 May 2005 19:57
		Re: BSR 710: repair or replace? By: skyeenter on Fri, 03 June 2005 21:54

Previous Topic:	Anyone know where to purchase good quality outer sleeves for box sets?
Next Topic:	Mass and tonearm geometry/Empire

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 04 03:48:05 CST 2024