AudioRoundTable.com: Source » Systemdek 2 bearing

Home » Audio » Source » Systemdek 2 bearing

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Systemdek 2 bearing [message #11973 is a reply to message #11961]

Sat, 05 March 2005 09:44

kyle
Messages: 17
Registered: May 2009

Chancellor

One other thing you should try. Remove the spindle and take the ball bearing off of the end. These usually have a flat spot from years of abrasion. Rotate it so that the flat area is not on the bottom. This gives you a new bearing point and the bottom of the bearing well is usually flat or at least has marginal wear.

Report message to a moderator

[Message index]

		Systemdek 2 bearing By: newto on Wed, 23 February 2005 00:47
		Re: Systemdek 2 bearing By: BillEpstein on Wed, 23 February 2005 03:04
		Re: Systemdek 2 bearing By: DRCope on Wed, 23 February 2005 18:02
		Re: Systemdek 2 bearing By: audio origami on Wed, 02 March 2005 10:48
		Re: Systemdek 2 bearing By: Manualblock on Wed, 23 February 2005 06:40
		Re: Systemdek 2 bearing By: kyle on Mon, 28 February 2005 17:26
		Re: Systemdek 2 bearing By: DanR on Fri, 04 March 2005 07:53
		Re: Systemdek 2 bearing By: kyle on Sat, 05 March 2005 09:44
		For everyone, You're welcome. By: kyle on Thu, 10 March 2005 00:31

Previous Topic:	Turntable thrust bearing (replacement) alternative
Next Topic:	LAB 80

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 16:07:38 CST 2024