AudioRoundTable.com: Thermionic Emissions

Home » Audio » Thermionic Emissions » schematic

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: schematic [message #10935 is a reply to message #10934]

Sun, 06 February 2005 12:49

Manualblock
Messages: 4973
Registered: May 2009

Illuminati (13th Degree)

Well I would assume the 2a3 trans would be fairly inexpensive but for a 211 with 1100v on the plate might get pricey. The guys who built this went for about 800$ for the handwound power and opt's. Then 866 merc tubes and 211's as well as oil caps etc. the total came in at around 1k.
Then you like real nice chassis so add 150$ to that.

Report message to a moderator

[Message index]

		schematic By: Manualblock on Fri, 04 February 2005 17:33
		Re: schematic By: Wayne Parham on Sat, 05 February 2005 08:20
		Re: schematic By: Manualblock on Sun, 06 February 2005 09:32
		Re: schematic By: Wayne Parham on Sun, 06 February 2005 09:50
		Re: schematic By: Manualblock on Sun, 06 February 2005 12:49
		Re: schematic By: Wayne Parham on Sun, 06 February 2005 13:44
		OPTs By: Damir on Sun, 06 February 2005 15:16
		Re: OPTs By: Wayne Parham on Sun, 06 February 2005 15:30
		Re: OPTs By: Damir on Mon, 07 February 2005 05:39
		Re: OPTs By: Manualblock on Mon, 07 February 2005 07:15
		211 SE By: Wayne Parham on Mon, 07 February 2005 09:11
		How about an 813? By: PakProtector on Tue, 08 February 2005 20:53
		Re: How about an 813? By: Manualblock on Wed, 09 February 2005 07:28
		Re: How about an 813? By: PakProtector on Wed, 09 February 2005 07:42
		Re: schematic By: GarMan on Wed, 09 February 2005 10:02
		SE opt's By: PakProtector on Wed, 09 February 2005 17:11
		Re: SE opt's By: Manualblock on Thu, 10 February 2005 10:10

Previous Topic:	PSUD/switchercad
Next Topic:	Really cool DIY Rogue's Gallery I fell over

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 22 05:13:25 CST 2024