AudioRoundTable.com: Thermionic Emissions » Interpreting tube setup in a Leben CS-600

Home » Audio » Thermionic Emissions » Interpreting tube setup in a Leben CS-600

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Interpreting tube setup in a Leben CS-600 [message #96628 is a reply to message #96620]

Thu, 13 April 2023 22:00

gofar99
Messages: 1949
Registered: May 2010
Location: Southern Arizona

Illuminati (5th Degree)

Hi, That is a good question and not clear from the schematic. But since there are two tubes per channel I would expect the voltage amp stage to use the low power portions of each tube and the inverter/driver to use the high power sections. According to my RCA book the low power section if pins 6,7,8 and the high power one 1, 3 and 9. heaters are 4 and 5. I hope this helps. let us know.

Good Listening
Bruce

Report message to a moderator

[Message index]

		Interpreting tube setup in a Leben CS-600 By: kasperbergholt on Tue, 11 April 2023 07:03
		Re: Interpreting tube setup in a Leben CS-600 By: gofar99 on Thu, 13 April 2023 22:00
		Re: Interpreting tube setup in a Leben CS-600 By: kasperbergholt on Sun, 16 April 2023 11:05

Previous Topic:	Leben CS600X - Class AB or pure class A?
Next Topic:	Tube amps on PC.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 09:04:27 CST 2024