AudioRoundTable.com: Thermionic Emissions » New Millett Hybrid Done!

Home » Audio » Thermionic Emissions » New Millett Hybrid Done!

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: New Millett Hybrid Done! [message #9436 is a reply to message #9435]

Tue, 20 December 2005 19:05

Shane
Messages: 1117
Registered: May 2009

Illuminati (3rd Degree)

The knobs are Guasti Wire knobs from Marvac Electronics. I actually got them for another project, but liked the way they looked on the Millett. The top is a 1.5" x 1/8" aluminum bar stock piece that "free floats" so I can get to the bias points. The wood on either side that holds the aluminum down is 1/4" zebrawood that I cut an edge groove in to overlap the metal. The box is bamboo (6"x9"x3"). It's not quite as nice as I'd hoped, but considering the tools I have to work with it came out nice enough.

Report message to a moderator

[Message index]

		New Millett Hybrid Done! By: Shane on Tue, 20 December 2005 09:18
		Re: New Millett Hybrid Done! By: Wayne Parham on Tue, 20 December 2005 09:22
		Re: New Millett Hybrid Done! By: Shane on Tue, 20 December 2005 09:56
		Re: New Millett Hybrid Done! By: Shane on Tue, 20 December 2005 10:27
		Re: New Millett Hybrid Done! By: MQracing on Tue, 20 December 2005 18:23
		Re: New Millett Hybrid Done! By: Shane on Tue, 20 December 2005 19:05
		Re: New Millett Hybrid Done! By: Steve Eddy on Wed, 21 December 2005 19:40
		Re: New Millett Hybrid Done! By: Shane on Wed, 21 December 2005 20:28

Previous Topic:	Powrtron
Next Topic:	Pinging MQracing

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 22 20:11:38 CST 2024