AudioRoundTable.com: Thermionic Emissions

Home » Audio » Thermionic Emissions » Point to Point vs PCB

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Point to Point vs PCB [message #93784 is a reply to message #93783]

Tue, 18 May 2021 07:43

Rusty
Messages: 1340
Registered: May 2018
Location: Kansas City Missouri

Illuminati (3rd Degree)

The last kit build I did was all p to p. Much slower than circuit board. Just from stringing and crimping then soldering and trimming excess leads. I definitely like solid wire hookup to strand wire. Regardless the type. Making that good weld without glomming on too much solder is a skill not to be disregarded.

Report message to a moderator

[Message index]

		Point to Point vs PCB By: smartt on Fri, 16 April 2021 17:46
		Re: Point to Point vs PCB By: gofar99 on Fri, 16 April 2021 20:52
		Re: Point to Point vs PCB By: smartt on Fri, 16 April 2021 21:28
		Re: Point to Point vs PCB By: Wayne Parham on Sat, 17 April 2021 10:04
		Re: Point to Point vs PCB By: gofar99 on Sat, 17 April 2021 11:43
		Re: Point to Point vs PCB By: smartt on Sat, 17 April 2021 13:43
		Re: Point to Point vs PCB By: Wayne Parham on Sat, 17 April 2021 14:46
		Re: Point to Point vs PCB By: smartt on Sat, 17 April 2021 18:33
		Re: Point to Point vs PCB By: positron on Mon, 17 May 2021 20:35
		Re: Point to Point vs PCB By: Rusty on Tue, 18 May 2021 07:43
		Re: Point to Point vs PCB By: positron on Sun, 08 August 2021 12:44

Previous Topic:	Why parafeed?
Next Topic:	Western Electric 80th anniversary "300B" tube

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 23 10:31:48 CDT 2025